What is floor-to-floor height, and why it throws off a desk-based storey count

If you've ever pulled a building height off lidar or an assessor record and divided by 3 meters to guess at storey count, you've already hit the problem. Floor-to-floor height, the vertical distance from one floor slab to the next, isn't a fixed number. It changes by building type, by era, and sometimes floor by floor within the same structure. Treat it as a constant and your desk-based storey count will be off on exactly the buildings where it matters most: the ones you're scoping for a rooftop lease or co-location site without a visit.
Why floor-to-floor height isn't a fixed number
A typical office floor runs 3.9 to 4.2 meters, floor to floor. Residential buildings run tighter, often 3.0 to 3.3 meters, because apartment units don't need the plenum space for ductwork and cable tray that commercial tenants do. Ground-floor retail in a mixed-use building is frequently double height, 5 to 6 meters, to fit storefront glazing and mezzanine storage. Parking podiums sit lower per level but the structural slab-to-slab can still add up oddly against the floors stacked on top. Warehouses and light industrial buildings can run 6 meters or more per level and sometimes have no intermediate floor at all despite looking tall from the street.
Put a 42-meter rooftop into a flat 3.5-meter-per-floor assumption and you get 12 floors. But if the ground floor is a 6-meter retail base and the rest of the building runs 3.3 meters, the real count is closer to 11. One floor sounds like rounding error until it's the floor you're using to clear a parapet, size a rooftop lease envelope, or decide whether a candidate site even clears the RF clutter around it.
Where the error shows up on a candidate list
Mechanical penthouses and parapet walls add height without adding a storey, which pushes a naive height/3m calculation high. Older downtown buildings, especially pre-1960s construction, often have shorter floor-to-floor heights than anything built in the last two decades, which pushes the calculation low. Hospitals and hotels mix tall ground-floor lobby space with short, repetitive room-module floors above it, so no single per-floor assumption fits the whole building. None of this shows up when you're working from a rooftop height value alone and a rule of thumb for storey height.
The practical effect on a site-acquisition desk is a candidate list where the "storey count" column is a guess dressed up as a number. Antenna clearance checks run against the wrong assumed rooftop line. Co-location screening ranks a 14-story building against an 11-story one when they're actually close in usable rooftop space. And when a landlord's own records disagree with the desk estimate, which they often do on older buildings or ones that've had additions, there's no way to tell from the desk which figure is closer without someone driving out to look.
Sending a surveyor to confirm storey count on every candidate in a search ring isn't realistic when you're screening dozens of rooftops before a single site visit gets scheduled. Planning department records help, but they go stale fast and don't cover every parcel, especially on commercial buildings that have been renovated since the file was last updated.
This is the gap Storey Estimation was built to close. Instead of a flat per-floor assumption applied to a height value, it works from the building height itself, derived from very-high-resolution stereo or shadow imagery refreshed on an annual cadence, and converts that into an estimated storey count per building, delivered as a CSV or layer attribute you can drop straight into a candidate screening spreadsheet. Storey Estimation's rooftop height and storey workflow is built around exactly this problem: getting a usable storey estimate onto a desk-based candidate list without anyone setting foot on the property.
If floor-to-floor assumptions are quietly skewing your candidate rankings, it's worth running your search ring through Storey Estimation before the next round of landlord outreach goes out.